■Monitor-related Functions
The following functions related to monitors are configurable.
08/21/2001 6:50:08 PM 
Clock
Monitor status
|
|
|
|
|
|
|
|
M1 | K1 | T01 |
|
|
|
| |
C01 | camera | title |
| ALARM10* | |||
|
|
|
| ||||
Camera title | Event | ||||||
●Monitor Selection
It is necessary to select a monitor when controlling the
SETUP MENU.
STILL* (Still spot** or still multiscreen display is activat- ed.)
* ”STILL” appears when a Multiplexer board is installed inside the matrix switcher.
**Available only during playback
Note: When pressing the associated numeric button (1 to
5)while holding down the OSD button, information is turned on or off.
●The Display Position
The display position of the information is adjustable with the joystick on the system controller.
●Priority Lock
Priority lock is the function to prevent other operators' con- trol of a monitor even after the system
While the priority lock is active, the monitor is operable by the locking operator and
●Information Displayed on the Monitors
The following information is displayed on monitors.
Time and Date
Time and date are displayed.
The date display is selectable from five patterns, and the time display is selectable from 24- or 12- hour system.
The date display pattern (Example: August 21, 2001) 21/08/2001 08/21/2001
21/Aug/2001
2001/08/21
Aug/21/2001
Camera Title
The camera number and characters (up to 20) can be con- figured as a camera title.
The title is displayed in one line.
Monitor Status
The following status is displayed in one line. Mn (Monitor number)*
Kn (Controller number)*
Tnn (Monitor mode: the example shows the tour sequence)*
* "n" is the number.
Event
The information related to system operation is displayed. An alarm control, alarm suspension, and timer event are the example.
ALARMnn (The alarm is operating.)
ALARMnn ACK (The alarm has been acknowledged.) Tnn (Timer event: tour sequence number)
LOSS CHnn (the video loss channel number) ALM SUSPENDED (The alarm is suspended.)
●Sequence Mode
Camera images are displayed for a fixed time, and they are sequentially switched.
The change from a tour sequence into the spot mode is also possible.
Before use, the parameters of the sequence, such as a camera or monitor selection and dwell time need to be con- figured.
There are two sequences:
•Tour sequence
•Group sequence
Tour Sequence
The images through Camera 1 to 16 are displayed on a given monitor in the desired sequence.
CH1 | CH2 |
CH3
A tour sequence is consisted of 16 steps and up to 16 sequences are configurable.
Up to 30 seconds are selectable as each step's dwell time. Each step can call the desired preset position of a camera to be displayed.
15
