Recorder Control: Click on the desired radio button to determine the recorder type.

OFF: Select this when no recorder is connected to the unit.

HD100: Select this when a WJ-HD100 Series recorder is connected to the unit.

HD500: Select this when a WJ-HD500 Series recorder is connected to the unit.

The factory default setting is HD500.

Unit Address

This parameter is configurable only when HD100, HD200 or HD500 is selected in the Recorder window. When OFF is selected there, this parameter is dis- played in gray and not configurable. 1 to 99 is selec- table. The factory default setting is 1.

Note: If you use a time-lapse VCR for the recorder, do the recorder setting in SETUP MENU. (Refer to RECORDER in p. 60.)

EXT IN: This stands for the setting of the EXT IN con- nector at the unit's rear panel.

GEN LOCK ON: Select this mode to gen-lock the unit with the recorder.

GEN LOCK OFF: Select this mode if the asynchronous unit is connected to the recorder.

Notes:

If GENLOCK ON is selected, the playback images can- not be displayed on the monitors which are connected to the connectors MONITOR OUT 1 to 4. Confirm the images on those which are connected to the recorder.

If GENLOCK OFF is selected, the maximum rate recording becomes unavailable for WJ-HD500 Series.

When a Multiplexer board is installed in the unit, you can select either HD100 (Recorder window) or VCR (610 RECORDER CONTROL in SETUP MENU). (Refer to p. 60 for SETUP MENU.)

When you select HD100 or VCR, make sure EXT IN is set to GENLOCK OFF.

Put a File to SX150

Pressing this button will start the putting of the configuration data from the PC to the unit.

How to Display

To display this window, click on the (Put to SX150) button in the main window (p. 65).

Parameters

The file name of the configuration data appears.

(OK) button

To put the configuration file from the PC to the unit, click on this button.

(Cancel Exit) button

To cancel the putting of the configuration data from the PC to the unit, click on this button.

Notes:

The setup file has been configured at the factory, and the file names appear on the main window's title bar.

Put the file from the PC to the unit when the time with no necessary to the continuous system operation, such as after-hours. After the file putting, the system will auto- matically restart. Then, the system controllers will tem- porarily log out.

To change a file, select a file again. (Refer to p. 84 Select Setup Data File.)

The configuration file cannot be put to the unit while opening SETUP MENU.

It takes a few seconds to put a file to SX150, and you might assume the PC has been freezing.

Wait until the message “Completed!” appears on the screen. If the message “Connection error” appears, the PC is incorrectly connected to the unit. Confirm the set- tings of WJ-SX150 Administrator Console and retry the file putting.

(Refer to p. 61 SERIAL PORT SPEED and p. 86 Communication Port.)

67

Page 65
Image 65
Panasonic WJ-SX 150 manual Put a File to SX150, Unit Address, OK button, Cancel Exit button