MONITOR CONTROL
Refer to the system controller’s operating instructions before you login the system. After the
The operation begins with selecting a monitor, then the selected camera appears the active monitor.
■Monitor Selection
Unit addresses are given to each monitor.
Rotary SW | Mon 1 | Mon 2 | Mon 3 | Mon 4 |
|
1 | 1 | 2 | 3 | 4 |
|
The following is how to select a monitor.
1.Press the numeric button(s) to select the desired moni- tor's unit address.
2.Press the UNIT button.
The selected monitor will be activated.
■Priority Lock
You can apply or release priority lock by entering the func- tion code. Monitor display is the same as those of terminal mode. (Refer to p. xx for the illustrations.)
1.Select the desired monitor. (Refer to Monitor Selection).
2.Press the SHIFT button, and enter 101 by pressing the numeric buttons.
3.Press the FUNCTION button. The function will be exe- cuted.
If the priority lock mode is selected, the monitor number will inversely appear on the active monitor.
4.To release the priority lock, do steps 2 and 3 again.
Note: This function will prevent operators in the terminal mode from gaining control of a monitor. However, oper- ators via the PS·Data protocol can still gain control.
