Alarm Group
REC Mode: Select the desired setting by clicking on the radio button.
EXT: Select this to
INT: Select this if the asynchronous unit is connected to the unit. When it is activated, the
The factory default setting is EXT.
DYNAMIC REC: Select the desired setting by clicking on the
GROUP: Select this to give recording priority to a group of up to 4 camera channels associated to the alarm input. When you select this, the Group Setting but- ton becomes active. By pressing the button, the Mux Alarm Group window will be displayed so that you can configure the ALM 1 to 16 parameters. (Refer to Mux Alarm Group.)
OFF: Select this to deactivate the alarm priority mode.
The factory default setting is OFF.
• System Group
Camera SW Loss: Select the desired setting by click- ing on the
ON: “CAM SW LOSS” will blink on the associated moni- tor when loss of the camera switching pulse is detected.
OFF: “CAM SW LOSS will not appear on the monitor.
The factory default setting is ON.
Dummy Black: Select the desired setting by clicking on the
ON: The black image will be displayed for a camera channel that is not connected to the camera.
OFF: The camera channel will be skipped in the sequence/spot mode.
The factory default setting is ON.
(Save Exit) button
Saves the configuration and closes the Multiplexer Mode window.
(Cancel Exit) button
Cancels the configuration and closes the Multiplexer Mode window.
●Mux Alarm Group
This is a submenu of the Multiplexer window. In this win- dow, up to 4 cameras are given recording priority for each alarm input.
•Click a
•To configure ALM 9 to 16, click on the ALM 9 – 16 tab.
(Save Exit) button
Saves the configuration and closes the FS Board Alarm Group window.
(Cancel Exit) button
Cancels the configuration and closes the FS Board Alarm Group window.
83
