Alarm Mode

This window configures the operation parameters when an alarm signal is input: an alarm mode, auto reset time and alarm input.

(Save Exit) button:

Saves the configuration and closes the Daylight Saving

Time window.

(Cancel Exit) button:

Cancels the configuration and closes the Daylight Saving

Time window.

How to Display

To display this window, click on the (Alarm Mode) but- ton in the main window (p. 65).

Parameters

• Alarm Mode

Checking on the box of the desired alarm mode.

OFF: The system operation does not change into any other mode.

Sequence Mode: Camera images are displayed on the monitor in either the spot mode or tour sequence. When more than one alarm are input, the image associated to each alarm is displayed in the sequence mode.

Note: Click on the Dwell drop-down menu to select the dwell time.

Hold Mode: Camera images are displayed on the mon- itor in either the spot mode or tour sequence. Even more than one alarm are input, the image associat- ed to the initial alarm is continuously displayed.

Notes:

• The alarm mode is activated when alarm input signals are assigned to the same monitor through 420 ALARM EVENT or the Alarm Event (refer to p. 56 or p. 74) win- dow.

• While alarm is activated, you cannot operate the func- tions related to the multiplexer board.

• Alarm Input Group

Select the alarm input to be accepted. Multiple Selection is available.

Camera

72

This stands for that an alarm input is accepted via the CAMERA IN connectors or the RS-485 ports.

ON: The alarm-associated sequence/spot image is dis- played on a monitor, and alarm recording will start (if a recorder is connected to the unit).

Page 70
Image 70
Panasonic WJ-SX 150 manual Alarm Mode, Alarm Input Group, Camera