Paradyne 317x E1 manual Displaying LED Conditions, Status Perf TStat LED, Select LEDs E1 Prt1 Prt2

ACCULINK 317x E1 DSU/CSU

Displaying LED Conditions

The same conditions monitored by the front panel LEDs can also be monitored by the LED command. This command is most useful when the E1 DSU/CSU is being accessed remotely (see Appendix G, Front Panel Emulation). When using Front Panel Emulation, no LEDs are shown on the PC's screen; you must use the Stat command procedure described below to get LED information.

To display LED conditions on the front panel screen,

1.Press F1 to select Stat from the top-level menu screen.

DSU E1 CEPT

Stat	Test	Cnfig
F1	F2	F3

2.From the Status screen, press the key to display the LED selection.

Status:
DevHS STest		Perf
F1	F2	F3

3. Select LED from the Status screen.

Status:

Perf TStat LED

F1 F2 F3

4.From the Select LEDs screen, press the Function key that corresponds to E1 or the port for which you want to display LEDs. Use the scroll keys, if necessary.

Select LEDs:

E1 Prt1 Prt2

F1 F2 F3

If you chose E1, the LED Display screen lists the LED signals, two at a time, on the second line. A vertical bar at the left of the LED name indicates the condition is ON, while an underscore indicates the condition is Off.

LED Display:

_Test _NetSig

F1 F2 F3

If you chose a port, the Port n LEDs screen lists the LED signals, two at a time, on the second line. A vertical bar at the left of the LED name indicates the condition is ON, while an underscore indicates the condition is Off.

Port n LEDs: _DTR _TXD

F1 F2 F3

5.Use the and keys to scroll LED names onto the screen.

3-10 December 1996 3170-A2-GB20-20