Powerware 650825 kVA operation manual Isbm and UPM Sections Joined, UPM Wireway

UPS SYSTEM INSTALLATION

UPM Wireway

(Power wiring harnesses are coiled in this area.)

Figure 4-6. ISBM and UPM Sections Joined

10.Reinstall the left top panel (see Figure 4-5)and secure using the retained hardware.

NOTE Three flat cabinet joining brackets are provided in the hardware kit for securing the ISBM and UPM sections at the top front, top rear, and front base (see Steps 11 and 12).

11.Locate the hardware kit (packed inside a drawstring bag tied to the left middle panel of the UPM section). Locate two flat brackets and screws from the hardware kit. Align the holes in the flat brackets over holes in the top rear and top front of the ISBM and UPM sections. Secure the brackets with the screws from the hardware kit (see Figure 4-7).

12.Locate one flat bracket and screws from the hardware kit. Align the holes in the flat bracket over holes in the front base of the ISBM and UPM sections. Secure the bracket with the screws from the hardware kit (see Figure 4-7).

13.Proceed to paragraph 4.4.

EATON Powerware® 9395 UPS (650–825 kVA) Installation and Operation Manual S 164201725 Rev 2 www.powerware.com 4−7