UPS SYSTEM INSTALLATION

Installation Checklist

-All packing materials and restraints have been removed from each cabinet.

-Each cabinet in the UPS system is placed in its installed location.

-Joining brackets are installed between the ISBM and UPM sections.

-Intercabinet power wiring is installed between the ISBM and UPM sections.

-Intercabinet interface wiring is installed between the ISBM and UPM sections.

-A cabinet grounding/mounting kit is installed between the ISBM and UPM sections.

-All conduits and cables are properly routed to the UPS and any ancillary cabinets.

-All power cables are properly sized and terminated.

-Neutral conductors are installed or bonded to ground per requirements.

-Battery cables are terminated on E4 (+) and E5 (–).

-Battery aux contact signal wiring is connected from the UPS to the battery disconnect.

-Battery shunt trip signal wiring is connected from the UPS to the battery disconnect. (OPTIONAL)

-LAN and telephone drops are installed.

-All telephone and LAN connections have been completed.

-A ground conductor is properly installed.

-Air conditioning equipment is installed and operating correctly.

-The area around the installed UPS system is clean and dust-free. (It is recommended that the UPS be installed on a level floor suitable for computer or electronic equipment.)

-Adequate workspace exists around the UPS and other cabinets.

-Adequate lighting is provided around all UPS equipment.

-A 120 Vac service outlet is located within 7.5 meters (25 feet) of the UPS equipment.

-The REPO device is mounted in its installed location and its wiring is terminated inside the UPS cabinet.

-The normally−closed (NC) Emergency Power−off contact (pins 1 and 2 on TB1) is jumpered if not used.

-Alarm relays and building alarms are wired appropriately. (OPTIONAL)

-A remote battery disconnect is mounted in its installed location and its wiring is terminated inside the UPS. (OPTIONAL)

-Accessories are mounted in installed locations and wiring is terminated inside the UPS cabinet. (OPTIONAL)

-The debris shields covering the UPS cabinet ventilation grills are removed.

-Startup and operational checks are performed by an authorized Eaton Customer Service Engineer.

EATON Powerware® 9395 UPS (650–825 kVA) Installation and Operation Manual S 164201725 Rev 2 www.powerware.com

4−43

Page 89
Image 89
Powerware 650825 kVA operation manual Installation Checklist