Printronix P5000LJ user manual List Commands

Chapter 13 Complete Command List

List Commands

These commands list the current or working settings for a particular section within the command shell. To view stored settings in flash memory, you will need to add in stored within the beginning of any of the following commands. For example, list prn shows you the current prn settings but list stored prn shows you the settings sitting in flash memory. Normally these should match.

list arp

List the current ARP table that the NIC adheres to in a TCP/IP network.

list date

List the current date on the NIC.

list dest

List the current destination settings (e.g., names and mapped I/O ports, models, and logpaths).

list diff

List the differences between the current settings and the stored settings in flash memory. Normally, you want these values to match, so issue a save command followed by a reset.

list ifc

List the current UTP interface settings (e.g., link integrity).

list key

List the license details and license key number.

list logins

List any active user logins on the NIC.

list logpath

List the current logpath settings (e.g., names and mapped destinations).

list model

List the current model settings (e.g., names and mapped destinations).

list pserver

List the current general print server settings (e.g., print server name and Novell mode).

list prn

List the current parallel port setting (e.g., mode).

list rprinter

List any current RPRINTER definitions.

list snmp

List Trap Table containing SNMP Managers.

list sysinfo

List the current NIC system information (e.g., contact name and protocol stacks enabled).

list tcpip

List all current TCP/IP network settings (e.g., IP address and subnet mask).

254