Printronix P5000LJ user manual Error Writing

Fault Messages

Table 24. LCD Message Troubleshooting Table (continued)

Displayed Message

Explanation

Action Required

ERROR: WRITING	Hardware or software fault in flash	Download the program again.
TO FLASH	memory.	If the message occurs again,
		call your authorized Printronix
		representative.1
ERROR: WRONG	The printer received the complete	Download the program again.
CHECKSUM	program but the checksum did not	If the message occurs again,
	match. The data was corrupted	call your authorized Printronix
	during download.	representative.1
ETHERNET ADAPTER	NIC is processing the boot	None
BEING INITIALIZED	procedure.
ETHERNET	NIC has established	None
DETECTED	communication.
EXHAUST FAN FLT	Sensors cannot detect current in	Power off the printer and
	fan circuit.	remove the paper path. Check
		that the fan cable connector is
		connected. Check for
		obstruction of vents and fan
		airway, and remove any
		obstructions. Check for items
		beneath the printer blocking
		cabinet vents. Power back on
		the printer. If this message
		recurs, contact your
		authorized Printronix
		representative.1
FIRMWARE ERROR*	Application software tried to	Contact your authorized
	perform an illegal printer function	Printronix representative.1
	or damaged memory detected on
	board.
FRAMING ERROR	Serial framing error. (Serial	Check your serial host
	interface.)	interface parameter settings; if
		necessary, adjust them so that
		they match the settings of the
		attached host.
HAM. COIL OPEN*	Electrical malfunction of one or	Contact your authorized
	more hammer coils.	Printronix representative.1
HAMMER COIL BAD	Coil # failed current test at power-	Record message, clear to
X, X, X,...	up.	continue printing, and contact
		your authorized Printronix
		representative.
HB NOT INSTALLD*	Self-test does not detect hammer	Contact your authorized
	coils.	Printronix representative.1

285