Printronix P5000LJ user manual Interrupting a download will damage the flash memory on

Chapter 2 Installing Printer Emulations

22.At the command prompt on the computer type: filename.exe -pb<Enter>

where filename.exe is the file name you noted in step 18. This command decompresses the file on the hard drive and copies it as a binary file into the flash memory on the printer controller board.

Note	If you are loading the file using the LPT2 port on the computer, enter the
	following command:
	filename.exe -pb2 <Enter>
	The 9600 baud rate is the only selection older versions of MS-DOS can
	use. The baud rate information entered in the following commands must
	match the selection you made in step 13.
	If you are loading the file through the printer serial port, enter the following
	commands:
	mode COM1:9600,N,8,1,P<Enter>
	filename.exe -pbc1<Enter>

Caution	Do not interrupt the downloading process once it has started.
	Interrupting a download will damage the flash memory on the
	controller board and the NIC.

While the file is copied into memory, the printer LCD informs you of the load process and status.

23.When the new program has successfully loaded into memory and the printer has reset itself, set the printer power switch to O (Off).

24.Unplug the AC power cord from the printer.

25.Remove the CD from the host computer and store it with the printer.

26.Power off the computer.

27.If you had to install a data cable to the computer and printer in step 6., disconnect it from the computer and printer.

28.If required, reconnect the data input cable(s) to the printer.

Using the configuration printout(s) you made in step 1., reconfigure the printer and reload any optional font files.

36