Chapter 13 Complete Command List

Set the destination to handle only certain print services. To add a service, specify the service name. To disable a service, use - before the name. The available services are:

socket Direct socket printing via TCP/IP.

lpd LPR printing with TCP/IP including LPR clients on any platform.

lpsched LP or System V printing with TCP/IP. rprinter Novell RPRINTER support. pserver Novell PSERVER support.

netbios Windows 95 and Windows for Workgroups printing.

ftpd Printing using the File Transfer Protocol (ftp) via TCP/IP.

set dest from default

Set all destination settings back to factory defaults.

set dest from stored

Set all current destination settings to the values stored in flash memory.

set logpath logpath name newname

set logpath l1 name pagecount

Change the current name of the logpath to a new name as indicated by newname. This newname must be nine characters or less or it will be truncated. These names are case sensitive.

set logpath logpath type [[-]job] [[-]user] [[-]pgcnt] [[-]cksum] [[-]printer] [[-]ioport]

set logpath l2 type job user printer pgcnt

Establish the type of printer and print job logging to be done within this logpath. The options are:

job Job ID, username, etc.

user User ID along with three messages per job about start and finish.

pgcnt For total pages printed in a job.

cksum 16-bit checksum value to confirm integrity of data printed. printer For special printer feedback.

ioport Printer error messages determined through the parallel port pins.

248

Page 248
Image 248
Printronix P5000LJ user manual Set dest from default, Set dest from stored