Printronix P5000LJ Test Width, Paper Out Dots, System Memory, Hammer tips and platen may result

Auto Switching Submenu

Note	The printer must be printing the phase pattern of “H’s” when the Phasing
	Value is changed or the new phasing value will not be written into non-
	volatile RAM (NVRAM). If the value is changed when not printing, the
	printer will return to its default phasing value when powered off and then
	back on.
	• Paperout Adj. It is recommended that only a Hewlett-Packard Customer
	Service Engineer run this test.
	The Paperout Adj. allows the Customer Service Engineer to specify
	where the last line of text will print when there is a paper out condition.
	Setting this parameter correctly prevents printing on the platen. (See the
	P5000LJ Series Printers Maintenance Manual for more information.)
	• Burnin Test. Running this test is not recommended.
	• Print Error Log. Prints a log of the last 50 errors that have occurred in
	the printer.
	• Clear Error Log. Clears the error log.
	• E-Net Test Page. Prints the Ethernet statistics stored on the Ethernet
	adapter (if present).
	Test Width
	This parameter permits you to run the self-tests at full width or 80 columns.
Caution	This parameter must match paper width used. If full width is selected
	for use with 80-column or 8.5-inch wide paper, damage to the
	hammer tips and platen may result.
	Paper Out Dots
	It is recommended that only an authorized Printronix representative sets this
	parameter.
	Paper Out Dots allows the Customer Service Engineer to specify where the
	last line on the page will print when there is a paper out condition. Setting this
	parameter correctly prevents printing on the platen.
	System Memory
	This parameter displays the amount of RAM installed.

131