Printronix P5000LJ Set sysinfo logport nullsyslog, Set sysinfo email joe@192.75.11.5, Set time 10

Chapter 13 Complete Command List

Note This is not printer or job logging information.

set sysinfo logport nullsyslog

set sysinfo logport null

Define where the debugging information should be sent to. This can be sent to an output device off of the NIC I/O port or to a central TCP/IP host running a SYSLOG daemon. To set this host, use the command set sysinfo syslog hostIPaddress.

set sysinfo email emailname@IPaddress

set sysinfo email joe@192.75.11.5

Define the user email address to receive printer and job logging information from a particular logpath on the NIC. emailname is the host or IP name of the user, and IPaddress is the IP address where the mail is stored on your network.

set sysinfo syslog hostIPaddress

set sysinfo syslog 192.75.11.30

Set the IP address of the host running the SYSLOG daemon. NIC debugging or print job and printer logging information can be sent to that IP address.

set sysinfo dns DNSserverIPaddress

set sysinfo dns 192.75.11.2

Set your DNS server IP address so the NIC can resolve host names when used with its built-in Telnet and Ping clients.

set sysinfo descramblekey hexvalue

set sysinfo descramblekey 1234

Set the key value used for descrambling print jobs that have passed through the npscramble utility on a TCP/IP host. This key is a four-digit hexadecimal value obtained from the host software, npscramble. Within the npscramble source code, there is a variable called SR_KEY which contains the default key value. This can be changed to any four-digit value you would like.

set sysinfo module [[-]novell] [[-]netbios]

set sysinfo module -novell

Enable and disable certain network protocol stacks within the NIC. Sometimes it helps to disable any protocols you are not using on your network.

set time hours [minutes [seconds ]]

set time 10 30

Set the current time noting the hours based on the 24-hour system and the minutes and seconds ranging from 0 through 59. If the NIC is reset, this value will be lost so you will need to set the time again.

252