Printronix P5000LJ user manual Set dest d1prn backchannel prn save

c.set dest d1prn backchannel prn save

list dest (this will allow you to see your change) exit

5.The npconfig file is read each time the printer commands spooler nn;start or startspool nn are used, meaning if corrections are needed to the file it is not necessary to restart the HP e3000, only the spooler. Stop the spooler by using a stopspool command, then restart it using one of the commands described above.

Create or modify the npconfig file. As a starting point, you can use the system file npconfig.samp.

For each logical network printer that points to a physical NIC using the npconfig file entries, make the following minimum entries (assume a logical device 201 has been set in sysgen):

201 ( network_address = xxx.xxx.xxx.xxx tcp_port_number = 9100 pjl_supported = true

snmp_enabled = false jam_recovery = false data_timeout = 30 )

The entry snmp_enabled = false must be entered as shown.

If you have other HP LaserJet printers already configured while using a global setup_file entry, and you experience font or other difficulties with the P5000LJ line matrix printers, create a separate setup file which is empty to override the global entries. This may be required since the P5000LJ printer uses PCL Level II, which is a minimal set of PCL, and the typical HP e3000 global setup file may contain PCL commands beyond those in PCL II. This will not affect your ability to use the P5000LJ printer effectively. The syntax for the setup file is setup_file = name.

Use npconfig entries banner_header and banner_trailer for banner or trailer pages. Be aware that the default value is “true,” so banners will print by default.

167