Printronix P5000LJ user manual Npconfig.pub.sys Listing Comments

c.Place the printer online and wait for the front panel to display “E-Net Ready.” This will write the Gateway address to the network I/F NvRam.

d.Take the printer offline and enter the desired Gateway address.

e.Place the printer online and wait for the front panel to display “E-Net Ready.” This will write the Gateway address to the network I/F NvRam.

f.Print E-Net Test Page and verify both listed Netmasks are the same and that xxx.xxx.xxx.xxx is alive is printed under Default Gateway Ping Test (xxx.xxx.xxx.xxx = Gateway IP address).

5.Inspect “Printer Destinations” on the E-Net Test Page. Reprint the E-Net Test Page and verify the backchannel is set to prn for the d1prn queue. On an HP e3000 host, prn must be listed under BACK for the d1prn queue so that Printer Job Language (PJL) will operate properly. (PJL must be operational for Page Level Recovery [PLR] to function.) The backchannel for the d1prn printer queue can be set with a telnet session from a PC running a DOS session as shown below:

C:\telnet 15.31.40.147

Network Printer Server Version 1.1.3 (15.31.40.147) login: root

Password: (carriage return) Welcome root User

15.31.40.147:root> set dest d1prn backchannel prn ok

15.31.40.147:root> save 15.31.40.147:root> exit

6.The npconfig.pub.sys file is loaded each time the spooler is started. Verify the npconfig.pub.sys file contains the (pjl_supported), (snmp_enabled), and (data_timeout) lines for each P5000LJ printer. Here is a typical list of the npconfig.pub.sys entry for a P5000LJ printer:

npconfig.pub.sys Listing	Comments
6 Network Address = 192.6.1.71	IP address - no leading zeros
tcp port number = 9100	This line optional
setup file = SETUP6.PUB.SYS	Optional - specific setup file for LDev6
pjl supported = TRUE	Required for PLJ to function
snmp enabled = FALSE	Required
data timeout = 30	Required
banner header = false	Optional - turns off headers
banner trailer = false	Optional - turns off trailers

169