COMMAND LINE INTERFACE

Command

Function

Mode

Page

ip

Defines the default gateway through which an

GC

3-52

default-gateway

in-band management station can reach this

 

 

 

device

 

 

 

 

 

 

show ip interface

Displays the IP settings for this device

PE

3-53

 

 

 

 

show ip redirects

Displays the default gateway configured for

PE

3-54

 

this device

 

 

 

 

 

 

ping

Sends ICMP echo request packets to another

NE,

3-54

 

node on the network

PE

 

 

 

 

 

ip address

Use this command to set the IP address for this device. Use the no form to restore the default IP address.

Syntax

ip address {ip-address netmask bootp dhcp} no ip address

ip-address- IP address

netmask - Network mask for the associated IP subnet. This mask identifies the host address bits used for routing to specific subnets.

bootp - Obtains IP address from BOOTP.

dhcp - Obtains IP address from DHCP.

Default Setting

IP address: 0.0.0.0

Netmask: 255.0.0.0

Command Mode

Interface Configuration (VLAN)

Command Usage

You must assign an IP address to this device to gain management access over the network. You can manually configure a specific IP address, or direct the device to obtain an address from a BOOTP or DHCP server. Valid IP addresses consist of four numbers, 0 to 255,

3-50

Page 162
Image 162
SMC Networks SMC6750L2 manual Ip address