SMC Networks SMC6750L2 manual Enabling Snmp Management Access

BASIC CONFIGURATION

3.Type “exit” to return to the global configuration mode. Press <Enter>.

4.Type “ip dhcp restart” to begin broadcasting service requests. Press <Enter>.

5.Wait a few minutes, and then check the IP configuration settings, by typing the “show ip interface” command. Press <Enter>.

6.Then save your configuration changes by typing “copy running-config startup-config.” Enter the startup file name and press <Enter>.

Console(config)#interface vlan 1 Console(config-if)#ip address dhcp Console(config-if)#exit Console#ip dhcp restart Console#show ip interface

IP interface vlan

IP address and netmask: 10.1.0.54 255.255.255.0 on VLAN 1,

and address mode: User specified. Console#copy running-config startup-config Startup configuration file name []: startup

Console#

Enabling SNMP Management Access

The switch can be configured to accept management commands from Simple Network Management Protocol (SNMP) applications such as EliteView. You can configure the switch to (1) respond to SNMP requests or (2) generate SNMP traps.

When SNMP management stations send requests to the switch (either to return information or to set a parameter), the switch provides the requested data or sets the specified parameter. The switch can also be configured to send information to SNMP managers (without being requested by the managers) through trap messages, which inform the manager that certain events have occurred.

1-9