COMMAND LINE INTERFACE

Command Mode

Global Configuration

Command Usage

Bridge priority is used in selecting the root device, root port, and designated port. The device with the highest priority becomes the STA root device. However, if all devices have the same priority, the device with the lowest MAC address will then become the root device.

Example

Console(config)#bridge 1 priority 40000

Console(config)#

bridge-group path-cost

Use this command to configure the spanning tree path cost for the specified interface. Use the no form to restore the default.

Syntax

bridge-group bridge-grouppath-cost cost no bridge-group bridge-grouppath-cost

bridge-group- Bridge group index (bridge 1).

cost - The path cost for the port. (Range: 1-65535) The recommended range is:

-Ethernet: 50-600

-Fast Ethernet: 10-60

-Gigabit Ethernet: 3-10

Default Setting

Ethernet – half duplex: 100; full duplex: 95; trunk: 90

Fast Ethernet – half duplex: 19; full duplex: 18; trunk: 15

Gigabit Ethernet – full duplex: 4; trunk: 3

Command Mode

Interface Configuration (Ethernet, Port Channel)

3-88

Page 200
Image 200
SMC Networks SMC6750L2 manual Bridge-group path-cost