COMMAND LINE INTERFACE
ip igmp snooping version
Use this command to configure the IGMP snooping version. Use the no form to restore the default.
Syntax
ip igmp snooping version {1 2} no ip igmp snooping version
•1 - IGMP Version 1
•2 - IGMP Version 2
Default Setting
IGMP Version 2
Command Mode
Global Configuration
Command Usage
•All systems on the subnet must support the same version. If there are legacy devices in your network that only support Version 1, you will also have to configure this switch to use Version 1.
•Some commands are only enabled for IGMPv2, including ip igmp
Example
The following configures the switch to use IGMP Version 1:
Console(config)#ip igmp snooping version 1
Console(config)#
show ip igmp snooping
Use this command to show the IGMP snooping configuration.
Default Setting
None