COMMAND LINE INTERFACE

Example

The following shows LACP enabled on ports 11-13. Because LACP has also been enabled on the ports at the other end of the links, the show interfaces status port-channel 1 command shows that Trunk1 has been established.

Console(config)#interface ethernet 1/11

Console(config-if)#lacp

Console(config-if)#exit

Console(config)#interface ethernet 1/12

Console(config-if)#lacp

Console(config-if)#exit

Console(config)#interface ethernet 1/13

Console(config-if)#lacp

Console(config-if)#exit

Console(config)#exit

Console#show interfaces status port-channel 1

Information of Trunk 1

Basic information:

Port type: 100tx

Mac address: 00-00-e8-00-00-0b

Configuration:

Name:

Port admin status: Up

Speed-duplex: Auto

Capabilities: 10half, 10full, 100half, 100full,

Flow control status: Disabled

Current status:

Created by: lacp

Link status: Up

Operation speed-duplex: 100full

Flow control type: None

Member Ports: Eth1/11, Eth1/12, Eth1/13,

Console#

3-140

Page 252
Image 252
SMC Networks SMC6750L2 manual 140