COMMAND LINE INTERFACE

Command Mode

Global Configuration

Example

The following shows how to configure the query interval to 100 seconds:

Console(config)#ip igmp snooping query-interval 100

Console(config)#

ip igmp snooping query-max-response-time

Use this command to configure the snooping report delay. Use the no form of this command to restore the default.

Syntax

ip igmp snooping query-max-response-time seconds no ip igmp snooping query-max-response-time

seconds - The report delay advertised in IGMP queries. (Range: 5-30)

Default Setting

10 seconds

Command Mode

Global Configuration

Command Usage

The switch must be using IGMPv2 for this command to take effect.

The command sets the time the switch waits after receiving an IGMP report (for an IP multicast address) on a port before it sends an IGMP Query out that port and then removes the entry from its list.

Example

The following shows how to configure the maximum response time to

20 seconds:

Console(config)#ip igmp snooping query-max-response-time 20 Console(config)#

3-116

Page 228
Image 228
SMC Networks SMC6750L2 manual Ip igmp snooping query-max-response-time, 116