COMMAND LINE INTERFACE

Syntax

snmp-server host host-addr community-string no snmp-server host host-addr

host-addr- Name or Internet address of the host (the targeted recipient). (Maximum host addresses: 5 trap destination ip address entries)

community-string- Password-like community string sent with the notification operation. Though you can set this string using the snmp-server host command by itself, we recommend you define this string using the snmp-server community command prior to using the snmp-server host command. (Maximum length: 32 characters)

Default Setting

None

Command Mode

Global Configuration

Command Usage

If you do not enter an snmp-server host are sent. In order to configure the switch you must enter at least one snmp-serverto enable multiple hosts, you must issue a host command for each host.

command, no notifications to send SNMP notifications, host command. In order separate snmp-server

The snmp-server host command is used in conjunction with the snmp-server enable traps command. Use the snmp-server enable traps command to specify which SNMP notifications are sent globally. For a host to receive notifications, at least one snmp-server enable traps command and the snmp-server host command for that host must be enabled.

However, some notification types cannot be controlled with the snmp-server enable traps command. For example, some notification types are always enabled.

3-46

Page 158
Image 158
SMC Networks SMC6750L2 manual Syntax