Star Micronics LC-200 user manual Is there toomuchpaperinthe paperfeedhopperorstacker?

Check

Are you trying to feed paper using the front panel buttons while the ON LINE indicator is illuminated?

Is the paper too thick?

Possible remedy

You can only feed paper in this way when the printer is off-line. Set the printer off-line and then feed paper.

There are limitsto the thickness ofpaperthatcanbe fed

Iin this way. Try using thinner paper.

If the ASF is not operatingor is not feeding paper correctly,check the following:

Check

Has the ASF option been selected with the EDS switch?

Is the release lever set to the ~ position?

Is the ASF correctly mounted?

Is paper caught up near the print head?

Are the left and right guides too close together?

Is there toomuchpaperinthe paperfeedhopperorstacker?

Was the paper fanned before being fed into the ASF?

Has the paper been used al- ready or is it creased?

Are you hying to feed paper using the front panel buttons while the ON LINE indicator is illuminated?

Is the paper too thick or too thin?

Possible remedy

Select this option.

The release lever should be set to the single-sheet position.

Make sure that the ASF improperlyseatedontheprinter.

Stop printing, remove the jammed sheet (you may have to remove the ASF for this), and continue.

If the left and right guides are too close together, the paper will not feed smoothly. Move them a little further apart to allow the paper to feed freely.

The ASF’Spaper feed hopper and stacker can hold 50 sheets each. Make sure that there is no more paper than this in either the hopper or stacker.

If this is not done, paper jams may occur. Remove the stack of paper from the ASF and fan it before reinsert- ing.

Only new, uncreased paper should be used with the ASF.

You can only feed paper in this way when the printer is off-line. Set the printer off-line and then feed paper.

There are limits to the thickness ofpa~r that can be fed in this way. Try using different paper.