IES-1000 User’s Guide

When auto-negotiation is turned on, the Ethernet port of the IES-1000 negotiates with the peer Ethernet port on the Ethernet cable automatically to determine the optimal connection speed and duplex mode. If the peer Ethernet port does not support auto-negotiation or turns off this feature, the IES-1000 determines the connection speed by detecting the signal on the cable and using half duplex mode. When the IES-1000’s auto-negotiation is turned off, the Ethernet port uses the pre-configured speed and duplex mode settings when making a connection, thus requiring you to check the settings of the peer Ethernet port in order to connect.

11.9.1Ethernet Port Setup Screen

Click 0 in the Port Setup screen to open this screen.

 

 

Figure 11-4 Ethernet Port Setup

The following table describes this screen.

 

 

Table 11-5 Ethernet Port Setup

 

 

 

 

LABEL

DESCRIPTION

 

 

 

 

Port Setup

Click this link to go to the Port Setup screen.

 

 

 

 

Mode

Use the drop-down list box to select a speed and duplex setting for the Ethernet port. In

 

 

10/100Mbps Fast Ethernet, the speed can be 10Mbps or 100Mbps. The duplex mode can be

 

 

Half (meaning traffic is transmitted in one direction at a time) or Full (meaning traffic is

 

 

simultaneously transmitted in both directions). Select Auto to have the Ethernet port auto-

 

 

negotiate with a peer to obtain the connection speed and duplex mode.

 

Default 802.1p

Type the priority value (0 to 7) to add to incoming frames without a (802.1p) priority tag.

 

Priority

 

 

 

 

11-8

ADSL Module Port Setup