ZyXEL Communications IES-1000 6.4.1Typical Scenarios, 6.4.2Installation Scenario A, Figure 6-6AAM1008 Installation Overview

IES-1000 User’s Guide

Figure 6-6 AAM1008 Installation Overview

You can also use RJ-11 connectors on both ends of the telephone cables connect directly to an

ADSL modem(s) or patch panel. This chapter discusses connections using MDFs.

6.4.1Typical Scenarios

Your existing telephone wiring usually depends on your region. Here are descriptions of three typical installation scenarios. See the Notes About MDFs (Main Distribution Frames) for more information about MDFs. Use telephone wires with RJ-11 jacks on one end (follow the pin assignments shown in the appendices) for connecting to the AAM1008.

6.4.2Installation Scenario A

You want to install the AAM1008 network module in an environment where there are no previously installed MDFs. There is no phone service and you want to install the AAM1008 for data-access only. No connections from the CO ports are necessary.

You may connect using an MDF or attach RJ-11 connectors to the non-AAM1008 side of the telephone wire and then connect to ADSL modem directly.

6-6 Hardware Connections