24.3.23Set PVCs Command
Syntax:
192.168.1.1 adsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx vpi> <rx vci>]
where
multiplexing mode = either “llc” or “vc”
<tx vpi> | = The VPI setting of the ADSL ports for use with a Tx based network | ||
<tx vci> | = The VCI setting for the ADSL ports for use with a Tx based network | ||
<rx | vpi> | = | The VPI setting for the ADSL ports for use with Rx based networks |
<rx | vpi> | = | The VCI setting for the ADSL ports for use with Rx based networks |
The <rx vpi> and | <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx | ||
settings are not configured.
The set pvcs command allows you to configure a single PVC for all of the ADSL ports at once.
The following example sets all of the ADSL ports to use the LLC multiplexing mode, Tx VPI 8 and Tx VCI 33. The results of this command are reflected when you use the show pvcs command.
192.168.1.1 adsl> set pvcs llc 8 33
24.3.24Show PVC Command
Syntax:
192.168.1.1 adsl> show pvc <port number>
where
<port number> = A port number, from 1 to 8.
The show pvc command allows you to display the PVC parameters of an individual ADSL port. This command is equal to the show chs <port #> command (see section 26.3.5 Show Channels Command).
24.3.25Show PVCs command
Syntax:
192.168.1.1 adsl> show pvcs
The show pvcs command allows you to display the PVC parameters of all ADSL ports. This command is equal to the show chs command (see section 26.3.5 Show Channels Command).
ADSL Commands |