IES-1000 User’s Guide

Make sure that G.SHDSL ports five through eight are all the same end of their connections (all STU-C or all STU- R).

G.SHDSL ports one through four do not need to be set to be the same end of the connection as G.SHDSL ports five through eight. For example, G.SHDSL ports one through four could be set to be STU-C while G.SHDSL ports five through eight are set to be STU-R.

The following example sets an STU-R 8-wire mode (4 ports) group with the name “N-wire-B” for ports 1 to 4.

192.168.1.1 gshdsl> set nwirer 8w N-wire-B 1

Make sure you set all of the ports in an n-wire group to have the same PVID see section 31.3.3 PVID Command.

If the ports are enabled and you change them from central side to remote side or vice versa (all ports are set to the central side by default), the system will take a few moments to process the change. If the ports are not enabled, the processing occurs when you enable them. During this processing the system appears to be hanging.

25.3.24Set Central Side Port Bonding Command

Syntax:

192.168.1.1 gshdsl> set bondc <bond name> <port list> or

192.168.1.1 gshdsl> set bondc <mode> <bond name> <group list>

where

<bond name>

=

The name of the bonding group (up to 31 characters).

<port list>

=

Two to eight G.SHDSL ports.

<mode>

=

Type “4w” to bond 4-wire (two port) n-wire groups together.

 

 

Type “8w”to bond 8-wire (four port) n-wire groups together.

 

 

 

 

 

You must use the set nwirec command to configure the 4 or 8-

 

 

wire bundled groups before you can use this command to bond

 

 

them.

<group list> =

When you select 4-wire or 8-wire mode, list the member groups for this port

 

 

bonding group. You must have already used the set nwirec command to

configure the 4 or 8-wire groups and the groups cannot be members of another port bonding group. Configure the groups on both ends of a connection with the same number of 4 or 8-wire groups.

This command bonds the specified member list into a single port for the STU-C (SHDSL Termination Unit – Central). One SAM1008 must be set to be the central side and the other must be set to be the remote side. Configure both with the same number of ports set to connect to the other SAM1008 and bonded.

You can bond multiple groups of ports as long as they do not overlap. One SAM1008 module can have both STU- C and STU-R groups.

Make sure that G.SHDSL ports one through four are all the same end of their connections (all STU-C or all STU- R).

25-12

G.SHDSL Commands