networks.
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx settings are not configured.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual G.SHDSL port.
25.3.18Set PVCs Command
Syntax:
192.168.1.1 gshdsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx vpi> <rx vci>]
where
<multiplexing mode>= | Either “llc” or “vc”. | |
<tx vpi> | = | The VPI setting of the G.SHDSL ports for use with a Tx based |
|
| network. |
<tx vci> | = | The VCI setting for the G.SHDSL ports for use with a Tx based |
|
| network. |
<rx vpi> | = | The VPI setting for the G.SHDSL ports for use with Rx based |
|
| networks. |
<rx vpi> | = | The VCI setting for the G.SHDSL ports for use with Rx based |
|
| networks. |
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx settings are not configured.
The set pvcs command allows you to configure a single PVC for all of the G.SHDSL ports at once.
25.3.19Show PVC Command
Syntax:
192.168.1.1 gshdsl> show pvc <port #>
where
<port #> = | A port number, from 1 to 8. |
This command allows you to display the PVC parameters of an individual G.SHDSL port. This command is equal to the show chs <port #> command (see section 26.3.5 Show Channels Command).
25.3.20Show PVCs Command
Syntax:
192.168.1.1 gshdsl> show pvcs
This command allows you to display the PVC parameters of all G.SHDSL ports.
G.SHDSL Commands |