3Com WX1200 set ip ssh

170 CHAPTER 7: IP SERVICES COMMANDS

History — Introduced in MSS Version 3.0.

Examples — The following command enables the SNMP server on a WX switch:

WX4400# set ip snmp server enable

success: change accepted.

See Also

set port trap on page 90

set snmp community on page 175

set ip ssh Changes the TCP port number on which a wireless LAN switch listens for

Secure Shell (SSH) management traffic.

CAUTION: If you change the SSH port number from an SSH session, MSS

immediately ends the session. To open a new management session, you

must configure the SSH client to use the new TCP port number.

Syntax — set ip ssh port port-num

port-num — TCP port number.

Defaults — The default SSH port number is 22.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Examples — The following command changes the SSH port number on

a WX switch to 6000:

WX4400# set ip ssh port 6000

success: change accepted.