clear {ap | dap} radio 287
Defaults — The clear ap radio command resets the radio to the default
settings listed in Table50 and in Table 66 on page 362.
Access — Enabled
History —Introduced in MSS Version 3.0.
Usage — When you clear a radio, MSS performs the following actions:
Clears the transmit power, channel, and external antenna setting from
the radio.
Removes the radio from its radio profile and places the radio in the
default radio profile.
This command does not affect the PoE setting.
Examples — The following command disables and resets radio 2 on the
MAP access point connected to port 3:
WX1200# clear ap 3 radio 2
Table50 Radio-Specific Parameters
Parameter Default Value Description
channel 802.11b — 6
802.11a — Lowest
valid channel number
for the country of
operation
Number of the channel in
which a radio transmits and
receives traffic
tx-power Highest setting allowed for
the country of operation
or highest setting
supported on the
hardware, whichever is
lower.
Transmit power of a radio, in
decibels referred to
1 milliwatt (dBm)
antennatype For most MAP models, the
default is internal.
For MP-620, the default
for the 802.11b/g radio is
ANT-1360-OUT. The
default for the 802.11a
radio is ANT-5360 OUT.
The default for the
802.11b/g radio on model
MP-262 is ANT1060.
External antenna model
Note: This parameter is
configurable only on MAPs
that support external
antennas.