3Com WX1200 set igmp lmqi

434 CHAPTER 13: IGMP SNOOPING COMMANDS

set igmp lmqi Changes the IGMP last member query interval timer on one VLAN or all

VLANs on a wireless LAN switch.

Syntax — set igmp lmqi tenth-seconds [vlan vlan-id]

lmqi tenth-seconds — Amount of time (in tenths of a second) that

the WX waits for a response to a group-specific query after receiving a

leave message for that group, before removing the receiver that sent

the leave message from the list of receivers for the group. If there are

no more receivers for the group, the WX switch also sends a leave

message for the group to multicast routers. You can specify a value

from 1 through 65,535.

vlan vlan-id — VLAN name or number. If you do not specify a

VLAN, the timer change applies to all VLANs.

Defaults — The default last member query interval is 10 tenths of a

second (1 second).

Access — Enabled.

History — Introduced in MSS Version 3.0.

Examples — The following command changes the last member query

interval on VLAN orange to 5 tenths of a second:

WX1200# set igmp lmqi 5 vlan orange

success: change accepted.