184 CHAPTER 7: IP SERVICES COMMANDS
ip-addr[:udp-port-number] — IP address of the server. You also
can specify the UDP port number to send notifications to.
community-string — Community string.
profile profile-name — Notification profile this SNMP user will use
to specify the notification types to send or drop.
retries num — Notification profile this SNMP user will use to specify
the notification types to send or drop.
timeout num — Specifies the number of seconds MSS waits for
acknowledgement of a notification. You can specify from 1 to 5
seconds.
SNMPv2c with Traps To configure a notification target for traps from SNMPv2c, use the
following command:
Syntax — set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string trap
[profile profile-name]
target-num — ID for the target. This ID is local to the WX switch and
does not need to correspond to a value on the target itself. You can
specify a number from 1 to 10.
ip-addr[:udp-port-number] — IP address of the server. You also
can specify the UDP port number to send notifications to.
community-string — Community string.
profile profile-name — Notification profile this SNMP user will use
to specify the notification types to send or drop.
SNMPv1 with Traps To configure a notification target for traps from SNMPv1, use the
following command:
Syntax — set snmp notify target target-num ip-addr[:udp-port-number]
v1 community-string
[profile profile-name]
target-num — ID for the target. This ID is local to the WX switch and
does not need to correspond to a value on the target itself. You can
specify a number from 1 to 10.
ip-addr[:udp-port-number] — IP address of the server. You also
can specify the UDP port number to send notifications to.