3Com WX1200 - page 82

82 CHAPTER 4: PORT COMMANDS

dap-num — Number for the Distributed MAP. The range of valid

connection numbers depends on the WX switch model:

For a WX4400, you can specify a number from 1 to 256.

For a WX1200, you can specify a number from 1 to 30.

serial-id serial-ID — MAP access point serial ID. The serial ID is

listed on the MAP case. To show the serial ID using the CLI, use the

display version details command.

radiotype 11a | 11b| 11g — Radio type:

11a — 802.11a

11b — 802.11b

11g — 802.11g

This option applies only to single-radio models.

Defaults — The default values are the same as the defaults for the

set port type ap command.

Access — Enabled.

History — Introduced in MSS Version 3.0. New values for model option

added in Version 4.1:

AP3750

AP2750

mp-620

Examples — The following command configures Distributed MAP 1 for

MAP model AP2750 with serial-ID M9DE48B012F00:

WX4400# set dap 1 serial-id M9DE48B012F00 model ap2750

success: change accepted.

The following command removes Distributed MAP 1:

WX4400# clear dap 1

This will clear specified DAP devices.

Would you like to continue? (y/n) [n]y