set port type ap 91
set port type ap Configures an WX switch port for a MAP access point.
CAUTION: When you set the port type for MAP use, you must specify
the PoE state (enable or disable) of the port. Use the WX switch’s PoE to
power 3Com MAP access points only. If you enable PoE on a port
connected to another device, physical damage to the device can result.
Before configuring a port as a MAP access point port, you must use the
set system countrycode command to set the IEEE 802.11
country-specific regulations on the WX switch. See “set system
countrycode” on page 56.
For a MAP that is indirectly connected to the WX switch through an
intermediate Layer 2 or Layer 3 network, use the set dap command to
configure a Distributed MAP.
Before changing the port type from ap to wired-auth or from
wired-auth to ap, you must reset the port with the clear port type
command.
Syntax — set port type ap port-list model {ap2750 | ap3750|
ap7250 | ap8250 | ap8750 | mp-52 | mp-241 | mp-252 | mp-262 |
mp-341 | mp-352 | mp-372 | mp-372-CN | mp-37-JP | mp-620}
poe {enable | disable}
[radiotype {11a | 11b | 11g}]
port-list — List of physical ports.
model {ap2750 | ap3750| ap7250 | ap8250 | ap8750 | mp-52 |
mp-241 | mp-252 | mp-262 | mp-341 | mp-352 | mp-372 |
mp-372-CN | mp-37-JP | mp-620} — MAP access point model:
poe enable | disable — Power over Ethernet (PoE) state.
radiotype 11a |11b | 11g — Radio type:
11a — 802.11a
11b — 802.11b
11g — 802.11g
This option does not apply to single-radio models.
Defaults — All WX ports are network ports by default.