3Com WX1200 - page 274

274 CHAPTER 10: NETWORK DOMAIN COMMANDS
clear
network-domain
Clears all Network Domain configuration and information from a WX
switch, regardless of whether the WX switch is a seed or a member of a
Network Domain.
Syntax — clear network-domain
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Examples — This command has no effect if the WX switch is not
configured as part of a Network Domain.
To clear a Network Domain from a WX switch within the domain, type
the following command:
WX1200# clear network-domain
This will clear all network-domain configuration. Would you
like to continue? (y/n) [n] y
success: change accepted.
See Also
set network-domain mode member seed-ip on page 280
set network-domain peer on page 281
set network-domain mode seed domain-name on page 282
clear network-domain peer on page276
clear network-domain seed-ip on page 277
display network-domain on page 278
Table47 Network Domain Commands by Usage (continued)
Type Command