set dap auto 325
set dap auto Creates a profile for automatic configuration of Distributed MAPs.
Syntax — set dap auto
Defaults — None.
Access — Enabled.
History — Introduced in MSS 4.0.
Usage — Table65 lists the configurable profile parameters and their
defaults. The only parameter that requires configuration is the profile
mode. The profile is disabled by default. To use the profile to configure
Distributed MAPs, you must enable the profile using the set dap auto
mode enable command.
The profile uses the default radio profile by default. You can change the
profile using the set dap auto radio radio-profile command. You can
use set dap auto commands to change settings for the parameters listed
in Table65. (The commands are listed in the “See Also” section.)
Table65 Configurable Profile Parameters for Distributed MAPs
Parameter Default Value
MAP Parameters
mode disabled
bias high
upgrade-firmware
(boot-download-enable) enable (YES)
group (load balancing group) none
blink
(Not shown in display dap config
output)
disable
Radio Parameters
radiotype (type) 11g
(or 11b for country codes where
802.11g is not allowed)
mode enabled