set {ap | dap} name 333
If you use the name none, spelled in any combination of capital or
lowercase letters, the specified MAP access point is cleared from all MAP
access point groups.
Examples — The following command configures a MAP access point
group named loadbalance1 that contains the MAP access points on ports
1, 3, and 5:
WX1200# set ap 1,3,5 group loadbalance1
success: change accepted.
The following command removes the MAP access point on port 4 from all
MAP access point groups:
WX1200# set ap 4 group none
success: change accepted.
See Also
display {ap | dap} config on page 290
display {ap | dap} group on page 303
set {ap | dap} name Changes a MAP name.
Syntax — set {ap port-list | dap dap-num} name name
ap port-list — List of ports connected to the MAP access point to
rename.
dap dap-num — Number of a Distributed MAP to rename.
name — Alphanumeric string of up to 16 characters, with no spaces.
Defaults — The default name of a directly attached MAP is based on the
port number of the MAP access port attached to the MAP. For example,
the default name for a MAP on MAP access port 1 is MAP01. The default
name of a Distributed MAP is based on the number you assign to it when
you configure the connection. For example, the default name for
Distributed MAP 1 is DAP01.
Access — Enabled.
History —Introduced in MSS Version 3.0. Default Distributed MAP name
changed from DMPnum to DAPnum in MSS Version 4.1.