set radius proxy port 493
Examples — The following command configures a RADIUS proxy entry
for a third-party AP RADIUS client at 10.20.20.9, sending RADIUS traffic
to the default UDP ports 1812 and 1813 on the WX:
WX4400# set radius proxy client address 10.20.20.9 key
radkey1
success: change accepted.
See Also
clear radius proxy client on page 488
set authentication proxy on page 241
set radius proxy port on page493
set radius proxy port
Configures the WX port connected to a third-party AP as a RADIUS proxy
for the SSID supported by the AP.
Syntax — set radius proxy port port-list [tag tag-value]
ssid ssid-name
port port-list — WX port(s) connected to the third-party AP.
tag tag-value — 802.1Q tag value in packets sent by the
third-party AP for the SSID.
ssid ssid-name — SSID supported by the third-party AP.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — AAA for third-party AP users has additional configuration
requirements. See the “Configuring AAA for Users of Third-Party APs”
section in the “Configuring AAA for Network Users” chapter of the
Wireless LAN Switch and Controller Configuration Guide.
Enter a separate command for each SSID, and its tag value, you want the
WX to support.