set spantree portfast 415
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command applies only to the default VLAN (VLAN1). To
change the cost of a port in another VLAN, use the set spantree
portvlancost command.
Examples — The following command changes the cost on ports 3 and 4
to 20:
WX1200# set spantree portcost 3,4 cost 20
success: change accepted.
See Also
clear spantree portcost on page 394
clear spantree portvlancost on page 395
display spantree on page 398
display spantree portvlancost on page 403
set spantree portvlancost on page 417
set spantree portfast
Enables or disables STP port fast convergence on one or more ports on a
wireless LAN switch.
Syntax — set spantree portfast port port-list {enable | disable}
port port-list — List of ports. MSS enables the feature on the
specified ports.
enable — Enables port fast convergence.
disable — Disables port fast convergence.
Defaults — STP port fast convergence is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Use port fast convergence on ports that are directly connected
to servers, hosts, or other MAC stations.