RCEI’
Recall Trace
Description
The state and trace data are recalled when the trace destination is trace A, trace B, or trace C.
When using a user-defined trace or a trace range for the trace destination, only the trace data
is recalled.
When recalling frequency-amplitude correction data, you need to specify AMPCOR as the
destination. When recalling limit line table data, specify LIMILINE as the destination.
To avoid overwriting the recalled trace data, the VIEW command should be performed
immediately after the RCLT command when recalling trace data (see line 40 in the example).
Note
The RCLT recalls trace data from spectrum analyzer memory. See “LOAD” or
“SAVRCLN” to recall trace data from the memory card.
Programming Commands 5-461