Chapter 1 49
Instrument Messages
Instrument Messages
Instrument Messages
651 Connect RF OUT to INPUT
Attempt to align the tracking generator without its output connected.
Connect the tracking generator RFOUT to the analyzer INPUT .
652 Connect Amptd Ref Output to Input
For Agilent Technologies E4402B, E4403B, E4404B, E4405B, E4407B, and
E4408B only: you must connect the AMPTD REF OUTPUT to the analyzer
INPUT with the appropriate cable.
653 Auto Align not available when using Calibration Defaults
The Auto Alignment system cannot be used until an Align Now All is
executed by pressing System, Alignments, Align Now, All. On all Agilent
Technologies ESA spectrum analyzer models except Agilent Technologies
E4401B and E4411B, you must connect the AMPTD REF OUT to the INPUT
with the appropriate cable to perform this alignment. For Agilent
Technologies E4401B and E4411B only: disconnect any signals from the
INPUT prior to performing this procedure.
701 Invalid printer response
In attempting to identify the printer an invalid response was received.
Check that you are using a supported printer. Be sure you are using the
proper cable and that it is securely fastened.
702 Unsupported printer
A printer which is recognized, but known to be unsupported was
identified. This printer cannot be used with the analyzer. For example, a
printer only supported by Microsoft Windows will generate this error.
703 Unknown printer
In attempting to identify the printer, a valid re sponse w as re ceived but the
printer is not known to the analyzer. Use the Custom printer menu under
Print Setup to configure the printer.
704 Printer interface error
An error occurred while trying to print. Make sure the printer is turned on
and properly connected.
705 Printer Type is None
The current printer type is set to None, so no print operations are possible.
Change the type in the Print Setup menu and try again.
727 In <filename>: [DATA] header missing
This message indicates that the data section of a file did not begin with the
token [DATA].