Chapter 1 59
Instrument Messages
Instrument Messages
Instrument Messages
10166 Cannot locate the file that contains the list of cable types.
The cable file may have been moved or deleted accidentally. Reinstall the
measurement personality. This message is applicable to the GSM (Option
BAH) and Distance to Fault (Option 226) measurement personality
options.
10167 The file containing the list of cable types has been updated.
10168 Cannot update the list of cable types on drive C:
The file update failed.
10170 The Cable Fault Measurement is active. Mode Setup is disabled.
Mode setup is not available in the cable fault utility.
10172 Sweep Time too fast (<2 sec)
The sweep time must be set to 2 seconds or longer for the results to be
valid.
10173 Carrier Not Present.
10177 There are no spurs to inspect.
You have attempted to switch the Inspect Spur menu key to the On position
after the measurement has finished, but found no spurs.
10178 Carrier Not Present.
10179 Carrier Present. Test Stopped!
A carrier was found in the transmit band. Either disable the carrier or
insert a bandpass filter for the receive bandwid th.
10180 Gate option not installed. Results may not be accurate.
This measurement method requires the use of the time-gate (option 1D6)
in order to gate the spectrum durin g the 50-90% part of the burst. If th e
gate option is not installed, the measurement will still run although this
warning will be displayed.
10181 Upper Custom Mask is Invalid!
The user-specified upper custom mask cannot be resolved into a limit line.
The format may be bad.
10182 Lower Custom Mask is Invalid!
The user-specified lower custom mask cannot be resolved into a limit line.
The format may be bad.
10183 Resolution BW < 300kHz.
The test will not meet EDGE specifications because the resolution BW has
fallen below 300 kHz.