56 Chapter 1
Instrument Messages
Instrument Messages
Instrument Messages
10141 Sync word not found in frame (Burst Type)
One or more active GSM bursts that match the selected burst type have
been detected in the RF input signal, but none contain the selected
Training Sequence Code (TSC). The search was performed over the
complete GSM frame.
10142 Sync word not found in specified timeslot (Burst Type)
One or more active GSM bursts that match the selected burst type have
been detected in the RF input signal, but none contain the selected
Training Sequence Code (TSC). The search was only performed over the
specified timeslot setting.
10143 Sync word not found in frame (Ref Burst)
One or more active GSM bursts that match the selected burst type have
been detected in the RF input signal, but none contain the selected
Training Sequence Code (TSC). The search was only performed using the
Reference Burst type and the Ref TSC settings over the complete GSM
frame.
10144 Unknown demod status
Demodulation is in an unknown state. Press Preset. If the error persists,
get in touch with your service center.
10145 Opt AYX hardware required. Meas unavailable.
Option AYX must be installed for this measurement to be enabled.
10146 Options B7D & B7E hardware required. Meas unavailable.
The RF Communications Hardware (Option B7E) and Digital Signal Fast
ADC (Option B7D) cards required to perform the demodulation are not
present in the analyzer.
10147 Opt B7D bootrom requires upgrade.
The (Option B7D) bootrom revision is not supported by the currently
loaded personality version. Refer to the user’s guide for the personality in
use.
10148 Opt BAH DSP algorithm files not installed. Meas unavailable.
Contact your Service Center.
The Digital Signal Processor algorithm files required to perform the
demodulation are not present in the analyzer.
10148 B7D DSP Code Fail. Reload Opt BAH. Contact your Service
Center.
The Digital Signal Processor algorithm files required to perform the
demodulation are not present in the IDSP: drive.