Agilent Technologies E4400-90246

Chapter 1 83

Instrument Messages

Informational <name1> <filename1> file renamed to <name2> <filename2>

File name1 has been successfully renamed to file name2.

Informational Atten auto set to 15 dB

Indicates that an input signal has been detected which is of sufficient level

to damage the input circuitry and the input attenuator has been

automatically set to 15dB. If the signal level is reduced, the attenuator

will stay at 15 dB. This overload protection occurs at an input power level

of 13 dBm (68dBmV for Option 1DP) ± 7 dB when the input attenuation is

auto coupled and set to <15 dB. To return to the original measurement

setup, reduce the input signal level and press Amplitude. Then press

Attenuation (Auto).

Overload protection is only available in the Agilent Technologies E4401B

and E4411B.

Informational Auto ranging...

Displayed during autoranging.

Informational B7D and/or B7E not found. Code Domain not available.

Digital Signal Processing and Fast Analog to Digital Converter (Option

B7D) and/or RF Communications Hardware (Option B7E) are not installed

options on your analyzer. Code domain is therefore not available.

Informational B7D and/or B7E not found. Mod Acc not available.

Digital Signal Processing and Fast Analog to Digital Converter (B7D)

and/or RF Communications Hardware (B7E) are not installed options on

your analyzer. Modulation accuracy is therefore not available.

Informational Carrier Not Present.

A carrier signal/burst is expected at the analyzer input. This signal cannot

be found; however, the measurement will still run. Check input signal

connection.

Informational Channel frequency outside device’s transmit band.

Reset channel number or frequency.

Informational Default spur table values loaded.

No spur table has been previously saved when the Out-of-Band Spurious

measurement begins. Press Meas Setup, Edit Table to enter the frequency

ranges of interest and press Save Table to save that information. This

saved table will be loaded the next time the measurement is run.