Agilent Technologies Z5623A manual Checking the Limit Test File

Performance Verification

Setting Up Limit Testing

Checking the Limit Test File

Step 1. Connect an RF cable from Port 1 of the network analyzer to Test Port 1 of the test set. Connect an RF cable from Port 2 of the network analyzer to the Reflection Port of the test set.

Step 2. If the test set is turned off, turn it on. If the test set is already turned on, turn it off, then back on again. This causes the test set to execute the “*rst;” command, which is equivalent to the “refl_01;” command combined with the “tran_08;” command.

Step 3. Recall the calibration file listed in Table 4-1on page 4-13. (Consult “How to Recall a Calibration” on page 4-14.) The resulting display should look something like Figure 5-17.

Figure 5-17 Insertion Loss Test Setup, Cal File Recalled

Agilent Technologies Z5623A Option H48 5 -17