AMD SC3200 manual Index F7h Second Level PME/SMI Status Register 4 RC, 220

32581C Core Logic Module - Bridge, GPIO, and LPC Registers - Function 0

Table 6-29. F0: PCI Header/Bridge Configuration Registers for GPIO and LPC Support (Continued)

Bit Description

3Keyboard/Mouse Access Trap SMI Status. Indicates whether or not an SMI was caused by a trapped I/O access to the keyboard or mouse.

0:No.

1:Yes.

To enable SMI generation, set F0 Index 82h[3] = 1.

2Parallel/Serial Access Trap SMI Status. Indicates whether or not an SMI was caused by a trapped I/O access to either the serial or parallel ports.

0:No.

1:Yes.

To enable SMI generation, set F0 Index 82h[2] =1.

1Floppy Disk Access Trap SMI Status. Indicates whether or not an SMI was caused by a trapped I/O access to the floppy disk.

0:No.

1:Yes.

To enable SMI generation, set F0 Index 82h[1] = 1.

0Primary Hard Disk Access Trap SMI Status. Indicates whether or not an SMI was caused by a trapped I/O access to the primary hard disk.

0:No.

1:Yes.

To enable SMI generation, set F0 Index 82h[0] = 1.

Index F7h Second Level PME/SMI Status Register 4 (RC) Reset Value: 00h

The bits in this register contain second level status reporting. Top level status is reported in F1BAR0+I/O Offset 00h/02h[0].

Reading this register clears the status at both the second and top levels except for bit 7 which has a third level of status reporting at F0BAR0+I/O 0Ch/1Ch.

A read-only “Mirror” version of this register exists at F0 Index 87h. If the value of the register must be read without clearing the SMI source (and consequently de-asserting SMI), F0 Index 87h can be read instead.

7GPIO Event SMI Status (Read Only, Read does not Clear). Indicates whether or not an SMI was caused by a transition of any of the GPIOs (GPIO47-GPIO32 and GPIO15-GPIO0).

0:No.

1:Yes.

To enable SMI generation, set F1BAR1+I/O Offset 0Ch[0] = 0.

F0BAR0+I/O Offset 08h/18h selects which GPIOs are enabled to generate a PME and setting F1BAR1+I/O Offset 0Ch[0] = 0 enables the PME to generate an SMI. In addition, the selected GPIO must be enabled as an input (F0BAR0+I/O Offset 20h and 24h).

The next level (third level) of SMI status is at F0BAR0+I/O 0Ch/1Ch.

6Thermal Override SMI Status. Indicates whether or not an SMI was caused by an assertion of the THRM#.

0:No.

1:Yes.

To enable SMI generation set F0 Index 83h[4] = 1.

5:4 Reserved. Read as 0.

3SIO PWUREQ SMI Status. Indicates whether or not an SMI was caused by a power-up event from the SIO.

0:No.

1:Yes.

A power-up event is defined as any of the following events/activities:

—RI2#

—SDATA_IN2

—IRRX1 (CEIR)

To enable SMI generation, set F1BAR1+I/O Offset 0Ch[0] = 0.

220 AMD Geode™ SC3200 Processor Data Book