AMD SC3200 manual Offset 0Ah-0Bh PM1AEN PM1A PME/SCI Enable Register R/W, 1511

Core Logic Module - SMI Status and ACPI Registers - Function 1 32581C

Table 6-34. F1BAR1+I/O Offset: ACPI Support Registers (Continued)

Bit Description

4BM_STS (Bus Master Status). Indicates if PME was caused by a system bus master requesting the system bus.

0:No.

1:Yes.

For the PME to generate an SCI, set F1BAR1+I/O Offset 0Ch[1] = 1 and F1BAR1+I/O Offset 0Ch[0] = 1. (See Note 2 in the general description of this register.)

Write 1 to clear.

3:1 Reserved. Must be set to 0.

0TMR_STS (Timer Carry Status). Indicates if SCI was caused by an MSB toggle (MSB changes from low-to-high or high-to- low) on the ACPI Timer (F1BAR0+I/O Offset 1Ch or F1BAR1+I/O Offset 1Ch).

0:No.

1:Yes.

For the PME to generate an SCI, set F1BAR1+I/O Offset 0Ah[0] = 1 and F1BAR1+I/O Offset 0Ch[0] = 1. (See Note 2 in the general description of this register.)

Write 1 to clear.

Offset 0Ah-0Bh PM1A_EN — PM1A PME/SCI Enable Register (R/W) Reset Value: 0000h

In order for the ACPI events described below to generate an SCI, the SCI_EN bit must also be set (F1BAR1+I/O Offset 0Ch[0] = 1).

The SCIs enabled via this register are globally enabled by setting F1BAR1+I/O Offset 08h. There is no second level of SCI status report- ing for these bits.

15:11 Reserved. Must be set to 0.

10RTC_EN (Real-Time Clock Enable). Allow SCI generation when the RTC generates an alarm (RTC IRQ signal is asserted).

0:Disable.

1:Enable

9 Reserved. Must be set to 0.

8PWRBTN_EN (Power Button Enable). Allow SCI generation when PWRBTN# goes low while the system is in a Working state.

0:Disable.

1:Enable

7:6 Reserved. Must be set to 0.

5GBL_EN (Global Lock Enable). Allow SCI generation when the BIOS releases control of the global lock via the BIOS_RLS (F1BAR1+I/O Offset 0Fh[1] and GBL_STS (F1BAR1+I/O Offset 08h[5]) bits.

0:Disable.

1:Enable

4:1 Reserved. Must be set to 0.

0TMR_EN (ACPI Timer Enable). Allow SCI generation for MSB toggles (MSB changes from low-to-high or high-to-low) on the ACPI Timer (F1BAR0+I/O Offset 1Ch or F1BAR1+I/O Offset 1Ch).

0:Disable.

1:Enable

Offset 0Ch-0Dh PM1A_CNT — PM1A Control Register (R/W) Reset Value: 0000h

15:14

Reserved. Must be set to 0.

AMD Geode™ SC3200 Processor Data Book 247