System Messages

B

 

Introduction to System Messages

System messages are logged automatically in an event log when problems or potential problems occur within the IVP System. The System Manager can access the event log by choosing Event Log Report from the System Report window. Use the procedures Viewing the Event Log and Using the Explain Command in Chapter 5 to read the Event Log Report. When an error message is read from the event log, refer to this section to determine the user action to be taken.

If the recommended action includes contacting a ‘‘field service representative,’’ call the appropriate customer support center for your telephone system. In this case call the National Service Assistance Center (NSAC) at 1-800-628-2888 for assistance or your AT&T Authorized Dealer.

Messages call attention to the following types of conditions:

software failures

hardware failures at the board level

diagnostic test results

alarm conditions

system restart conditions

B-1

Page 177
Image 177
AT&T 2.1.1 manual Introduction to System Messages