Installation

Installing the BayStack 350 Switch

This section explains how to install, power up, and verify the operation of the BayStack 350 switch. Before you begin these procedures, read and follow the instructions in “Site Preparation” on page 2-3.

Warning: To avoid bodily injury from hazardous electrical current, do not connect the power cord until instructed to do so.

You can install the BayStack 350 switch in any of the following locations:

Surface mounting

Tabletop or shelf (secured or unsecured)

Wall mount

Rack mounting

19-inch equipment rack

Surface Mounting

The BayStack 350 switch can be mounted on any surface that can safely support the weight of the switch and attached cables, as long as there is adequate space around the unit for ventilation and access to cable connectors. You can use the mounting brackets supplied with the switch to secure it to the installation location.

Note: In most cases, it is not necessary to secure the BayStack 350 switch to a tabletop or shelf. However, if conditions warrant securing the switch (for example, in locations where the switch might accidentally fall from a shelf or overhead location), you can secure the switch using two mounting brackets (supplied).

893-00992-B

2-5

Page 53
Image 53
Bay Technical Associates manual Installing the BayStack 350 Switch, Surface Mounting